Wodaplug Dual-Q 5G-RGM-O for Quectel RGMII to RJ45 Outdoor unit include 4x4 directional antenna V2 For DIY

This unit design for Qualcomm RGMII to PHY , test with quectel RM500Q Rm502Q RM510Q Rm520N RM551e RM521F 

We find a good outdoor enclousre (HW B222s-42a), make  a new 4x4 MIMO antenna, support from 600MHz-960MH &1710MHz-3800Mhz, frequency support 5Gnr N71 N1 N25 N41 N78  and LTE band1,2,3,4,5,8,25,26,38,40,41,66,71 , antenna VSWR test in below in picture section.

We recommend you use webui and RGMII to PHY project https://github.com/iamromulan/quectel-rgmii-configuration-notes

bracket and bracket install:https://youtu.be/V3oawqFvF3U

Packing list:

router board*1;  

water proof body case*1  (used have some scrtaches on the surface)

4x4 internal MIMO antenna

L bracket & accessories

2.5G 54V Power Over Ethernet adapter

You can configure it based on users guide. You can check for example https://github.com/iamromulan/cellular-modem-wiki/blob/main/quectel/flash_firmware_windows.md . Another sources - https://github.com/iamromulan/cellular-modem-wiki

QuecDeploy is good tool to download all needed Quectel sources.

Flashing firmware is easy under Widows, then you can also use QCom tool to set AT commands.

And here is the guideline example for the first use of the module on the adapter:
RM502QAE , RM500Q and RM520N-GL Configure 5G-RJ45 mini
1. AT+QCFG="data_interface",1,0 //open pcie net (click on send command and wait for OK response)
2, AT+QCFG="pcie/mode",1 //enable RC mode (click on send command and wait for OK response)
3, AT+QETH="eth_driver", "r8125" //select rtl8125 driver (click on send command and wait for OK response)
4, AT+QMAPWAC=1 //enable mobile AP auto dial (click on send command and wait for OK response)
5, save and restart to take effect : AT+CFUN=1,1 (click on send command)