Wodaplug ® Outdoor 5G 5GNR 4G LTE-A single module router MTK7621 board HW version 7 with switch to support Sierra EM919x and EM7690 modems, 1x LAN 1xWAN, 4 5G outdoor antennas, standalone: 1xM.2 USB3, 1xMiniPCIe, H721O can support 11ac WiFi (11ac 600VX or 900VX module ready, 11ac wave 2 QCA 9984, 9886 modules supported in new firmware). No modules included in, you need to order wifi and LTE 5G or 4G modules based on yoru needs, we will install and test all before shipment. High performance HW, new X-WRT high performance firmware ! OpenWRT supported

After makeing  H721 5G router , we fount that signal is very import for 5Gnr or LTE-A . So we designed a new outdoor unit, we find a good outdoor enclosure (HW B222s-42a), H721O outdoor most design are follow H721 indoor, you can use H721 indoor firmware resource at openwrt or X-WRT master

https://openwrt.org/toh/hwdata/dual-q/dual-q_h721

https://downloads.x-wrt.com/rom/x-wrt-24.01-b202401051651-ramips-mt7621-dual-q_h721-squashfs-sysupgrade.bin

Our new inventory of H721 routers were special ordered to better accommodate our customer’s needs. New improved 5G ready outdoor version ! Once again, if you want to have all info about ETA, versions,etc pls check our facebook page for news !

The H721O 5G NR outdoor version now includes:

• outer board*1;  water proof body case*1 ,700-5G PCB antenna ipex4 connector 25cm length *4, 4 L bracket & accessories ,POE is Huawei G

Hardware: 

MTK7621A Flash16M / RAM256M(CPU Cores:2 ;CPU MHz:880)

1x M.2 b.key USB 3.0 as 5Gnr interface,

1x Minipcie for PCIE wifi (such as AR928x QCA988x DR7915 ...)

2x FF4 nano sim slot (2ed sim slot follow quectel modem requirement)

Lightning protection design

 Heat sink at botoon of 5Gnr modem

NEW X-WRT firmware available !!!

Quectel EM12 4G IoT/M2M-optimized LTE-A Cat12 Module EM120K-GL 4G IOT Module Compatible EM06 EM16

EM120K-GL 4G LTE Cat12 Module Specifications:

* Product type: 4G Cellular Module
* Category: LTE Cat12 , LTE-A
* Chipset: Qualcomm
* Form factor: M.2, key-B
* Dimensions: 42.0 × 30.0 × 2.3mm
* Frequency Bands:
- LTE-FDD Bands: B1/B2/B3/B4/B5/B7/B8/B12/B13/B14/B17/B18/B19/B20/B25/B26/B28/B292/B30/B321/B66/B71
- LTE-TDD Bands: B34/B38/B39/B40/B41/B42/B43/B463(LAA)/B48 (CBRS)
- Up to 3 × CA: Intra-band and Inter-band
- WCDMA: B1/B2/B3/B4/B5/B6/B8/B19

Control via AT Commands: 3GPP TS27.007 and Quectel Enhanced AT Commands

* Target Market: Global

Pure 5G Outdoor Omni MIMO Antenna for 4G/5G 617-6000MHz

Model: 524LTE-TOF-0660-4DV-1

Electrical Specifications
Frequency-MHz 617-960/1710-3800/4900-6000
Gain-dBi 2.5 / 3.5 / 4
VSWR <2.5
Polarization Vertical
Horizontal Beam Width 360°
Vertical Beam Width 60°
Impedance 50 ohms
Max. Input Power 50W
Lightning Protection DC Ground

Mechanical Specifications
Connector 4×SMA male
Cable 1 meter RG405
Dimension Ø132*220 mm
Weight 1.2 kg
Mounting Mast Ø30-Ø50 mm
Radome Material UV PVC
Rate Wind Velocity 210km/h
Operating Temperature -40°C - +65°C

5G WWAN Card To RJ45 Adapter With SIM SloT

Product Model: 5G M.2 TO RJ45-KIT mini rev 2.0 . Lead time is 1-2 weeks, available for orders and tested well with Quectel RM50x modules ! R13 module firmware recommended. 

The product is compact, plug and play, no need to install drivers. just plug in the pre-configured  5G module + 5G antenna + 5G SIM card, connect the network cable to use the 5G network, stable performance, fast and convenient use.

The product used wide 5 to 28V Operating Input Range DC-DC, Can adapt to customer different power supply range of products. The DC-DC Up to 3A output current, effectively ensure the stability of the product work.
The product size is small, easy to use, and after the customer installed integration.It can help customers to realize machine networking, state monitoring, remote equipment maintenance and other application requirements. It is suitable for intelligent factory, robot, video surveillance, intelligent power, electronic sentry and other fields.

User can use the TYPE-C to USB line to connect the board and computer. Then user can use AT Commands in the QCOM tool to manage the module. It is not a router, just adapter, but user can configure the 5G module by AT commands

Newer mtk 7621 ZBT WG1608-5G truly 5G 4G LTE 2.4 5 Ghz metal body wifi router with best Rooter firmware, 7 antennas and power adapter included

Max. LAN Data Rate: 867Mbps

Standards And Protocols: Wi-Fi 802.11ac, Wi-Fi 802.11b, Wi-Fi 802.11g, Wi-Fi 802.11n

Wi-Fi Supported Frequency: 2.4G & 5G

Wi-Fi Transmission Standard: 802.11ac

Wired Transfer Rate: 10/100/1000Mbps

2.4G Wi-Fi Transmission Rate: 300 Mbps

Encryption Type: WPA-PSK

Function: FireWall, QoS, VPN

LANPorts:4 WAN Ports:1

USB 3.0 port: 1 included

Certification: FCC CE

5G Wi-Fi Transmission Rate: 867Mbps (limited by chipset peak speed)

Product name: Wifi Router ZBT WG1608-5G with M.2 slot for CAT12 CAT16 4G 5G Module (module not included in - please order it separately based on your region and needs),  Quetel RM520N-GL module supported as well as RM502Q and other Quectel modules !

Main Chipset: MT7621A (880MHz) Independent WIFI chip, 2.4G is MT7603EN, 5.8G is MT7613AEN FLASH/RAM: 16MB/256MB Interface: 1WAN+4LAN+1USB+1 Sim card slot+1 TF Port Protocol: 80.11ac / 802.11a / 802.11n / 802.11g / 802.11b Transmission rate: 1200Mbps 2.4G WIFI: 40MHz, 2x2 MIMO5.8GWIFI: 80MHz, 2x2 MU-MIMO Support: M.2 (4G and 5G choose one - 4G/5G module not included, please order it separately based on your region and needs)

WE1026 is a dual band 3G/4G Wi-Fi router (3G / 4G gateway) specially for Vehicles using. LTE 4G module is not included it - please order LTE 4G module based on yoru need. It can support Quectel LTE cat4 and cat 6 4G modules like EC25 and EP06. It has1 LAN port, support 802.11 a/b/g/n/ac and 3G/4G. This device has Wide Area Network VPN tunnel, Local Area Network Wi-Fi security authentication, 4G/3G and watchdog functions etc, to achieve wireless LAN seamless connection, automatic network redial to provide users with high-speed, secure, reliable mobile broadband services.It has a USB 2.0 data interface, a MICRO SD (TF) card interface, with larger storage function.

This device with metal case and vehicle anti-interference design, to achieve excellent anti-interference performance. Also it uses vehicle power supply design, support 9V~28V Car power supply,can effectively prevent equipment damage from vehicle’s power fluctuations, it offers a wonderful solution for vehicle Wi-Fi such as bus Wi-Fi,car Wi-Fi, train Wi-Fi, taxi Wi-Fi etc. This device also widely used in Wi-Fi coverage project like Bus station, the Airport, Sea port etc. At the same time, it is also widely used in scenic where Wi-Fi coverage and other public places where Wi-Fi coverage of the Internet.

• Special for Vehicles using;
• Complies with 802.11b/g/n/a/ac. wireless protocol;
• Support dual band 2.4G and 5G wifi signal + support 3G/4G at the same time;
• LTE 4G module is not included it - please order LTE 4G module based on yoru need. It can support Quectel LTE cat4 and cat 6 4G modules like EC25 and EP06.
• Support 4G / 3G watchdog function, automatic network redial.
• Can be dialed through an external USB interface (need to mount USB 3G/4G Dongle )
• Support GPS function (depending on 3G/4G module)
• Support to automotive power 12V and 24V systems, the minimum operating voltage is 9V, the maximum operating voltage is 36V. The maximum can be withstand 174V duration 150ms surge voltage, meet to 5a, 5b standard of the car protection.

Wodaplug 5G 4G LTE  Pigtail cable Ipex 4.0 head 1.20mm  Ø0.81mm cable , frequency MHF4 6GHz  Female / SMA Female 25cm, for M.2 modules with wide 1.5mm x height 0.6mm male ( quetel EM06 , EM12 , EM 20 , EM12-A , 5G RM500Q-GL etc.... )

Specially designed and shielded for 5G 4G technology signal transfer to avoid loose or interference.

Wodaplug 5G 4G LTE Ipex 4.0  Pigtail MHF4 Female / SMA Female 15cm thanks to new technologies compatible with new 5G & 4G modules as is EM06, EM12G , EM20G, RM500Q and many others M.2 LTE modules from quectel and Sierra Wireless and another brands

Description

DR-AP6018-A (Two Versions) is a 2x2 2.4G&5G high power Radio AP Router which including 1x DR6018(IPQ6018) Board;2 x 2.4G&5G dipole Antennas; 1 x PSU(DC power or PoE); 1 x Enclosure.

Dipole antenna ■ 2 x 2.4G&5G Antenna ■ 5dBi 2.4GHz/5Ghz ■ SMA Plug interface

■ Plastic rod of black ■ RoHS compliance Enclosure ■ Dimension: 192x 123 x 44 mm

■ Aluminum alloy material ■ Support Wallys’ PCBA Mainboard and OpenWRT and OpenWiFi firmware

QCN9074-6E with DR6018 Platform: Achieving 1.5Gbps Speed in Throughput Test!

Description DR-AP40X9-A is a 2x2 2.4G&5G high power Radio AP Router which including 1x DR40X9(IPQ4019/IPQ4029) Board

2 x 2.4G&5G dipole Antennas; 1 x PSU(DC power or PoE); 1 x Enclosure.

Dipole antenna ■ 2 x 2.4G&5G Antenna ■ 5dBi 2.4GHz/5Ghz

■ SMA Plug interface ■ Plastic rod of black

■ RoHS compliance Enclosure ■ Aluminum alloy material, FCC ID is 2AG7VDR4029

Dimension: 132x 119 x 34 mm

■ Our Firmware supports all the modules of Quectel

Support Openwifi

Support QSDK

Support Openwrt